Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 565 (Lighting Systems) >> Repair Instructions >> Hazard and Turn Signal Flasher Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Hazard & Turn Signal Flasher
    GM786886Courtesy of GENERAL MOTORS CORP.
  1. Install the flasher (1) to the fuse block until the retainer clicks into place.
  2. Install the knee bolster. Refer to Trim Panel Replacement - Knee Bolster in Instrument Panel, Gauges and Console.
scientia non olet · About Mike's Workshop Manuals