Inspection Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: DO NOT perform this procedure unless instructed by an Evaporative Emission (EVAP) diagnostic.

NOTE: Use EVAP Pressure/Purge Diagnostic Station (J-41413) in order to provide a clean, dry, low pressure gas source.

Turn ignition off. Remove EVAP canister purge solenoid. See EVAP CANISTER PURGE SOLENOID . Lightly tap the EVAP canister purge solenoid on a clean, hard surface. Inspect for carbon particles exiting either of the vacuum ports. If no carbon particles are found, reinstall EVAP canister purge solenoid and perform CLEANING PROCEDURE .
If carbon particles are found during the inspection procedure, replace EVAP canister purge solenoid and perform CLEANING PROCEDURE . If you were instructed to replace the EVAP canister purge solenoid, and no carbon particles are found, return to the EVAP diagnostic procedure. DO NOT perform the CLEANING PROCEDURE .