Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> Body & Frame >> Frames, Subframes & Crossmembers >> Frame And Underbody >> Repair Instructions >> Catalytic Converter Guard Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Catalytic Converter Guard
    GM794712Courtesy of GENERAL MOTORS CORP.
  1. Install the guard to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the mounting bolts.

    Tighten:  Tighten the bolts to 30 N.m (22 lb ft).

  3. Install the engine protection shield. Refer to Engine Protection Shield Replacement .
  4. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals