DTC P0111, P011B
DTC P0111 : IAT Sensor Circuit Range/Performance Problem DTC P011B : IAT Sensor Circuit Range/Performance Problem
NOTE: Before you troubleshoot, review the general troubleshooting information .
| DTC Description | Confirmed DTC | Pending DTC |
|---|---|---|
| P0111 IAT Sensor Circuit Range/Performance Problem | ||
| P011B IAT Sensor Circuit Range/Performance Problem |
DTC (PGM-FI)
- Connector visual check:
Check for poor connections or loose terminals at these locations:
- MAF sensor/IAT sensor
- ECT sensor 1
- ECT sensor 2
Are the connections and terminals OK?
YES
Go to step 2.
NO
Repair the connections or terminals.
- IAT sensor performance check (low temperature)
-1. Disconnect the following connector.
MAF sensor/IAT sensor 5P connector -2. Remove the MAF sensor/IAT sensor .
-3. Allow the MAF sensor/IAT sensor to cool to the ambient temperature.
-4. Note the ambient temperature.
-5. Connect the MAF sensor/IAT sensor to its 5P connector, but do not install it.
-6. Turn the vehicle to the ON mode.
-7. Quickly note the value of the IAT SENSOR in the DATA LIST with the HDS.
Signal Current conditions Values Unit IAT SENSOR (1) -8. Compare the value of the IAT SENSOR to the ambient temperature.
Does the value of the IAT SENSOR differ 5.4°F (3°C) or more from the ambient temperature?
YES
Replace the MAF sensor/IAT sensor .
NO
Go to step 3.
- IAT sensor performance check (high temperature)
-1. Turn the vehicle to the OFF (LOCK) mode.
-2. Disconnect the following connector.
MAF sensor/IAT sensor 5P connector -3. Using a heat gun, blow hot air on the MAF sensor/IAT sensor for a few seconds. Do not apply the heat longer than a few seconds or you will damage the sensor.
-4. Connect the MAF sensor/IAT sensor to its 5P connector, but do not install it.
-5. Check the IAT SENSOR in the DATA LIST with the HDS.
Signal Current conditions Values Unit IAT SENSOR (1) Does the IAT SENSOR change 76°F (42°C) or more?
YES
Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the MAF sensor/IAT sensor and the PCM. If the on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the on-board snapshot .
NO