Audio-Navigation System DTC 2703
DTC 2703 : Aircon Diag
NOTE:
- Check the vehicle 12 volt battery condition first .
- This navigation DTC sets when Connection NG is indicated in the Aircon diagnosis (the A/C icon is red in the System Links).
- Check for B-CAN DTCs and resolve them before troubleshooting.
- Before you troubleshoot, make sure to follow the General Troubleshooting Information .
- Check any official Honda service website for more service information about the navigation system.
- Check the connectors for poor connections or loose terminals.
- Problem verification
-1. Clear the hard error codes .
-2. Turn the vehicle to the OFF (LOCK) mode then the ON mode.
-3. Check for hard error codes .
Is DTC 2703 indicated?
YES
The failure is duplicated, go to step 2.
NO
Intermittent failure, the system is OK at this time.
- Open wire check (B-CAN_H, B-CAN_L lines)
-1. Turn the vehicle to the OFF (LOCK) mode.
-2. Disconnect the following connectors.
Audio-navigation unit connector B (20P) Climate control unit connector A (32P) -3. Check for continuity between test points 1 and 2.
Test condition Vehicle OFF (LOCK) mode Audio-navigation unit connector B (20P): disconnected Climate control unit connector A (32P): disconnected Test circuit 1 Test point 1 Audio-navigation unit connector B (20P) No. 3 Test point 2 Climate control unit connector A (32P) No. 24 Test circuit 2 Test point 1 Audio-navigation unit connector B (20P) No. 13 Test point 2 Climate control unit connector A (32P) No. 23 Is there continuity?
YES
Replace the climate control unit .
NO
Repair an open in the wire(s).