DTC P1172, P1174
DTC P1172 : Rear A/F Sensor (Bank 1, Sensor 1) Circuit Out of Range HighDTC P1174 : Front A/F Sensor (Bank 2, Sensor 1) Circuit Out of Range High
NOTE:
- Before you troubleshoot, review the general troubleshooting information - Refer to: HOW TO TROUBLESHOOT THE A/T SYSTEM (10-SPEED A/T) or HOW TO TROUBLESHOOT THE FUEL AND EMISSIONS SYSTEMS .
- Information marked with an asterisk (*) applies to the front bank (Bank 2).
| DTC Description | Confirmed DTC | Pending DTC |
|---|---|---|
| P1172 Rear A/F Sensor (Bank 1, Sensor 1) Circuit Out of Range High | ||
| P1174 Front A/F Sensor (Bank 2, Sensor 1) Circuit Out of Range High |
DTC (PGM-FI)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Start the engine.
-4. Hold the engine speed at 3,000 rpm without load (in P or N) until the radiator fan comes on, then let it idle.
-5. Monitor the OBD STATUS for P1172 and/or P1174 * in the DTCs MENU with the HDS.
DTC Description OBD STATUS P1172 Rear A/F Sensor (Bank 1, Sensor 1) Circuit Out of Range High P1174 Front A/F Sensor (Bank 2, Sensor 1) Circuit Out of Range High Does the HDS indicate FAILED?
YES
Replace the A/F sensor (Sensor 1) A/F SENSOR REMOVAL AND INSTALLATION .
NO
If the HDS indicates PASSED, intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the A/F Sensor (Sensor 1) and the PCM. If the on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the on-board snapshot - Refer to: HOW TO TROUBLESHOOT THE A/T SYSTEM (10-SPEED A/T) or HOW TO TROUBLESHOOT THE FUEL AND EMISSIONS SYSTEMS . If the HDS indicates EXECUTING, keep driving until a result comes on. If the HDS indicates OUT OF CONDITION, go to step 1-4 and recheck.