Cruise Control Combination Switch Removal, Installation, and Test: Test
- Cruise Control Combination Switch - Test
- Measure the resistance between the cruise control combination switch 12P connector (male terminals) terminals No. 3 and No. 10 according to the table.CRUISE CONTROL COMBINATION SWITCH RESISTANCE SPECIFICATION
Position Resistance at normal ambient temperature OFF (Released) 2.0-2.4 kΩ CRUISE/MAIN (Pressed and held) 54.3-66.3 Ω CANCEL (Pressed and held) 165.0-201.6 Ω SET-(Pressed and held) 401.8-491.0 Ω RES+(Pressed and held) 802.7-981.1 Ω If there is no resistance in one or more positions, replace the cruise control combination switch.
- Check the LED for illumination by applying power and ground to the terminals according to the table.NOTE: Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).
If the results are not as specified, replace the cruise control combination switch.
- Measure the resistance between the cruise control combination switch 12P connector (male terminals) terminals No. 3 and No. 10 according to the table.