DTC B12E4: Electric steering lock high level failure of MTRCUT2

DTC (Power Control Unit)

NOTE:  If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A - Refer to: Body Electrical Troubleshooting - B-CAN System Diagnosis Test Mode A - Initial Communication and DTC Checks .

Before troubleshooting, make sure the No. C32 (15 A) and No. C3 (10 A) fuses in the under-dash fuse/relay box are OK.

1. Problem verification:

   - 1. Turn the vehicle to the ON mode.

   - 2. Clear the DTCs with the HDS.

   - 3. Do this procedure 10 times: Turn the vehicle to the OFF (LOCK) mode, ACCESSORY mode, ON mode, and OFF (LOCK) mode.

   - 4. Turn the vehicle to the ON mode.

   - 5. Check for DTCs with the HDS.

   DTC Description	DTC
   B12E4 Electric steering lock high level failure of MTRCUT2

   Is DTC B12E4 indicated?

   YES 

   Go to step 2.

   NO 

   Intermittent failure, the system is OK at this time. Check for loose or poor connections.

2. Open wire check (GND line):

   - 1. Disconnect the following connectors.

   Electric steering lock 12P connector

   - 2. Check for continuity between test points 1 and 2.

   Test condition	Vehicle OFF (LOCK) mode. Electric steering lock 12P connector: disconnected
   Test point 1	Electric steering lock 12P connector No. 7
   Test point 2	Body ground

   Is there continuity?

   YES 

   The GND wire is OK. Go to step 3.

   NO 

   Repair an open or high resistance in the ground wire or poor ground (G401).

3. Open wire check (MTR CUT 2 (IG1) line):

   - 1. Disconnect the following connector.

   Keyless access control unit connector B (36P)

   - 2. Check for continuity between test points 1 and 2.

   Test condition	Vehicle OFF (LOCK) mode Electric steering lock 12P connector: disconnected Keyless access control unit connector B (36P): disconnected
   Test point 1	Electric steering lock 12P connector No. 4
   Test point 2	Keyless access control unit connector B (36P) No. 6

   Is there continuity?

   YES 

   Faulty electric steering lock, replace the steering lock. If the DTC is still present, replace the keyless access control unit .

   NO 

   Repair an open or high resistance in the wire.