Immobilizer Key Registration: Procedure

NOTE: 

• The HDS is required for registration of the immobilizer keys.
• Programming the immobilizer also programs the keyless transmitter.
• Check for aftermarket electrical equipment that can cause problems with transponder operation.
• The immobilizer-keyless control unit can store up to six immobilizer keys.

Replace any of the keys 

NOTE:  If any of the registered keys were lost, do the following procedure to delete the lost registered key.

1. Have at least one original key, all other keys to be registered and the immobilizer PCM code

2. Turn the vehicle to the ON mode

3. Select IMMOBI from the SYSTEM SELECTION MENU, then select IMMOBILIZER SETUP

4. Select KEYS from the IMMOBILIZER MENU, then select REWRITE KEYS

5. Do the registration according to the instructions on the HDS screen

6. Check if the engine can be started with the newly registered key

7. When prompted by the HDS, do the keyless transmitter programming

8. Make sure the keyless transmitter's operation works properly.

All Keys are Lost 

1. Prepare all new keys and have the immobilizer PCM code

2. Turn the vehicle to the ON mode

3. Select IMMOBI from the SYSTEM SELECTION MENU, then select IMMOBILIZER SETUP

4. Select KEYS from the IMMOBILIZER MENU, then select ALL KEYS LOST

5. Do the registration according to the instructions on the HDS screen

6. Check if the engine can be started with the newly registered keys

7. When prompted by the HDS, do the keyless transmitter programming

8. Make sure the keyless transmitter's operation works properly.