Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Honda >> 2014 >> Pilot EX-L, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 114 (EVAP System) >> EVAP Canister Replacement

EVAP Canister Replacement

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2014 Honda Ridgeline, 2013 Honda Ridgeline, 2012 Honda Ridgeline, 2011 Honda Ridgeline, and 2010 Honda Ridgeline. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle on a lift (see LIFT AND SUPPORT POINTS ).
  2. Remove the fuel tank guard (A).
    Fig 1: Fuel Tank Guard With Torque Specifications
    G05964805Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the hoses (A), the FTP sensor 3P connector (B), and the EVAP canister vent shut valve 2P connector (C).
    Fig 2: Hoses, FTP Sensor 3P Connector, EVAP Canister Vent Shut Valve 2P Connector And Bolts With Torque Specifications
    G05964806Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the bolts (D) and the clips (E).
  5. Remove the EVAP canister assembly (F).
  6. Remove the EVAP canister bracket (A).
    NOTE: The canister filter remains on the bracket.
    Fig 3: EVAP Canister Bracket With Torque Specifications
    G05964807Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Install the parts in the reverse order of removal.
scientia non olet · About Mike's Workshop Manuals