Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Honda >> 2014 >> Pilot EX, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (PGM-FI System) >> ECT Sensor 1 Replacement

ECT Sensor 1 Replacement

WARNING: This page is about a different car, the 2011 Honda Pilot, 2010 Honda Pilot, and 2009 Honda Pilot. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the engine coolant (see COOLANT CHECK ).
  2. Remove the engine cover (see step 1 on IGNITION COIL REMOVAL/INSTALLATION ).
  3. Disconnect the ECT sensor 1 2P connector (A).
    Fig 1: ECT Sensor 1 2P Connector With Torque Specifications
    G05969700Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove ECT sensor 1 (B).
  5. Install the parts in the reverse order of removal with a new O-ring (C), then refill the radiator with engine coolant (see COOLANT REPLACEMENT ).
scientia non olet · About Mike's Workshop Manuals