Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Honda >> 2014 >> Pilot EX, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Fuel And Emissions Systems) >> How to Set Readiness Codes >> EGR Monitor and Readiness Code >> Procedure

EGR Monitor and Readiness Code: Procedure

WARNING: This page is about a different car, the 2011 Honda Pilot, 2010 Honda Pilot, and 2009 Honda Pilot. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the HDS to the DLC.
  2. Start the engine.
  3. Drive at a steady speed with the transmission in D, at 50-62 mph (80-100 km/h) or above for more than 10 seconds.
  4. With the transmission in D, decelerate from 62 mph (100 km/h) or above by completely releasing the throttle for at least 5 seconds. If the engine is stopped during this procedure, go to step  3 and do the procedure again.
  5. Check the OBD status screen for DTC P0401 in the DTCs MENU with the HDS.
scientia non olet · About Mike's Workshop Manuals