Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Honda >> 2014 >> Fit >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Abs (Anti-Lock Brake System)) >> ABS Modulator - Control Unit Removal and Installation >> Removal

ABS Modulator - Control Unit Removal and Installation: Removal

WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to LOCK (0).
  2. Move the washer reservoir (see WIPER ARM REPLACEMENT ).
  3. Disconnect the ABS modulator-control unit 25P connector (A) by pulling up the lock (B); the connector disconnects itself.
    Fig 1: Identifying ABS Modulator-Control Unit Replacement Components With Torque Specifications
    G05959262Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Disconnect the six brake lines from the ABS modulator-control unit.
    NOTE: Brake lines are connected to the master cylinder (C) and to the right-front (D), the left-rear (E), the right-rear (F), and the left-front (G) brake systems.
  5. Remove the ABS modulator-control unit (H) with the bracket (I) from the body.
  6. Remove the ABS modulator-control unit from the bracket.
scientia non olet · About Mike's Workshop Manuals