Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Honda >> 2014 >> Fit >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Fuel And Emissions Systems) >> How to Set Readiness Codes >> EGR Monitor and Readiness Code >> Procedure

EGR Monitor and Readiness Code: Procedure

WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the HDS to the DLC.
  2. Start the engine.
  3. Drive at a steady speed, with the A/T in D or the M/T in 4th, at 50-62 mph (80-100 km/h) or above for more than 10 seconds.
  4. With the A/T in D or the M/T in 4th, decelerate from 62 mph (100 km/h) or above by completely releasing the throttle for at least 5 seconds. If the engine is stopped during this procedure, go to step  3 and do the procedure again.
  5. Check the OBD status screen for DTC P0401 in the DTCs MENU with the HDS.
    • If it is passed, readiness is complete.
    • If it is not passed, go to step  3 and retest.
scientia non olet · About Mike's Workshop Manuals