Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Honda >> 2014 >> Fit >> Repair and Diagnosis >> External Pages >> Different car >> Section 298 (Gauges - Testing & Troubleshooting) >> Connector For Inputs And Outputs >> Gauge Control Module Connector for Inputs and Outputs

Gauge Control Module Connector for Inputs and Outputs

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2020 Honda Fit, 2019 Honda Fit, 2018 Honda Fit, 2017 Honda Fit, and 2016 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
GHH81936Courtesy of HONDA, U.S.A., INC.
Terminal number Terminal name Description Signal
1 GND Ground for gauge control module Less than 0.2 V at all times
2 Not used --- ---
3 ILL- (LED) Outputs ILL- (LED) signal ---
4 PARKING BRAKE SW Detects PARKING BRAKE SW signal With vehicle in ON mode and parking brake switch OFF: about battery voltage With vehicle in ON mode and parking brake switch ON: less than 0.2 V
5 ILLUMI- (BULB) Outputs ILLUMI- (BULB) signal ---
6 BRAKE LEVEL SW Detects BRAKE LEVEL SW signal With vehicle in ON mode and brake fluid level switch OFF: about battery voltage With vehicle in ON mode and brake fluid level switch ON: less than 0.2 V
7*1 WASHER LEVEL SNSR Detects WASHER LEVEL SNSR signal With vehicle in ON mode and washer fluid level switch OFF: about battery voltage With vehicle in ON mode and washer fluid level switch ON: less than 0.2 V
8*2 VSA OFF SW Detects VSA OFF SW signal With vehicle in ON mode and VSA off switch OFF: about battery voltage With vehicle in ON mode and VSA off switch ON: less than 0.2 V
9*3 ILLUMI CANCEL Outputs ILLUMI CANCEL signal With combination light switch in PARKING and illumination full brightness: less than 0.2 V If none of above conditions are met: about 3 V
10 Not used --- ---
11 FUEL GAUGE+ Detects FUEL GAUGE+ signal With vehicle in ON mode: about 1.0 - 9.4 V (depending on fuel gauge sending unit)
12*4 TAM Detects TAM signal With vehicle in ON mode: about 0.2 - 4.9 V (depending on outside air temperature sensor)
13 Not used --- ---
14*5 CRUISE SW Detects CRUISE SW signal With vehicle in ON mode: about 0.8 - 4.4 V (depending on cruise control combination switch)
15 IG1 METER IG1 power source With vehicle in ON mode: about battery voltage
16 +B BACK UP Power source for gauge control module About battery voltage at all times
17 GND Ground for gauge control module Less than 0.2 V at all times
18 FUEL GAUGE- Ground for fuel gauge sending unit Less than 0.2 V at all times
19*5 CRUISE GND Ground for cruise control switch Less than 0.2 V at all times
20*3 OUTSIDE TEMP GND Ground for outside air temperature sensor Less than 0.2 V at all times
21 F-CAN_H Communication line ---
22 F-CAN_L Communication line ---
23 B-CAN_H Communication line ---
24 B-CAN_L Communication line ---
25 TPMS SW Detects TPMS SW signal With vehicle in ON mode and TPMS switch OFF: about battery voltage With vehicle in ON mode and TPMS switch ON: less than 0.2 V
26*6 ECON SW Detects ECON SW signal With vehicle in ON mode and ECON switch OFF: about battery voltage With vehicle in ON mode and ECON switch ON: less than 0.2 V
27 Not used --- ---
28 Not used --- ---
29 Not used --- ---
30 Not used --- ---
31 Not used --- ---
32 Not used --- ---

*1: Canada models

*2: With VSA

*3: With normal audio

*4: Without climate control

*5: With cruise control

*6: With ECON switch