DTC 1302: GPS Receiver Error 1

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2020 Honda Fit, 2019 Honda Fit, 2018 Honda Fit, 2017 Honda Fit, and 2016 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Check the vehicle 12 volt battery condition first .
This audio DTC sets when there is an internal GPS receiver problem (freeze error).
Before you troubleshoot, make sure to follow the General Troubleshooting Information - Refer to: How to Troubleshoot the Audio System, or Audio System Self-Diagnostic Function .

Problem verification:
- 1. Clear the hard error codes - Refer to: How to Troubleshoot the Audio System, or Audio System Self-Diagnostic Function .

- 2. Turn the vehicle to the OFF (LOCK) mode then the ON mode, and wait at least 1 minute.

- 3. Check for hard error codes - Refer to: How to Troubleshoot the Audio System, or Audio System Self-Diagnostic Function .

Is DTC 1302 indicated?

YES

Replace the audio unit - Refer to: Audio Unit Removal and Installation(With Normal Audio), or Audio Unit Removal and Installation(With Display Audio (7-inch Screen)), or Audio Unit Removal and Installation(With Color Audio (5-inch Screen)) .

NO

Intermittent failure, the system is OK at this time.

NOTE:

Check the vehicle 12 volt battery condition first .
This navigation DTC sets when there is an internal GPS receiver problem (freeze error).
Before you troubleshoot, make sure to follow the General Troubleshooting Information .
Check any official Honda service website for more service information about the navigation system.

Problem verification:
- 1. Clear the hard error codes Clear the hard error codes .

- 2. Turn the vehicle to the OFF (LOCK) mode then the ON mode, and wait at least 1 minute.

- 3. Check for hard error codes .

Is DTC 1302 indicated?

YES

Replace the audio-navigation unit .

NO

Intermittent failure, the system is OK at this time.