Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Honda >> 2014 >> CR-V EX, 2.4L Eng, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 102 (VTEC/VTC) >> Rocker Arm Oil Control Valve Removal/Installation

Rocker Arm Oil Control Valve Removal/Installation

WARNING: This page is about a different car, the 2011 Honda CR-V and 2010 Honda CR-V. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the under-cowl panel (see UNDER-COWL PANEL REPLACEMENT ).
  2. Disconnect the rocker arm oil control solenoid connector (A) and the rocker arm oil pressure switch connector (B).
    Fig 1: Rocker Arm Oil Control Solenoid Connector And Rocker Arm Oil Pressure Switch Connector With Torque Specifications
    G06610504Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the harness clamps (C) and the bolts (D).
  4. Remove the rocker arm oil control valve assembly (E) and the rocker arm oil control valve filter (F).
  5. Remove the engine wire harness bracket (A) from the rocker arm oil control valve (B).
    Fig 2: Engine Wire Harness Bracket And Rocker Arm Oil Control Valve With Torque Specifications
    G06610505Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Install the parts in the reverse order of removal with a new rocker arm oil control valve filter.
scientia non olet · About Mike's Workshop Manuals