Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Honda >> 2012 >> Fit Base, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Clutch) >> Clutch Replacement >> Engine Side >> Flywheel Replacement

Flywheel Replacement

WARNING: This page is about a different variant/trim than selected.
  1. Install the ring gear holder.
    Fig 1: Identifying Flywheel Mounting Bolts
    G05953320Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Loosen the flywheel mounting bolts in a crisscross pattern in several steps. Remove the bolts, then remove the flywheel and the ring gear holder.
  3. Install the flywheel on the crankshaft, and install the mounting bolts finger-tight.
  4. Install the ring gear holder (A), then torque the flywheel mounting bolts (B) in a crisscross pattern in several steps.
    Fig 2: Identifying Ring Gear Holder & Flywheel Mounting Bolts
    G05953321Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About Mike's Workshop Manuals