Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Honda >> 2012 >> Fit Base, Automatic Trans >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wipers/Washers >> Washer Motor Test

Washer Motor Test

  1. Remove the right inner fender (see FRONT INNER FENDER REPLACEMENT ).
  2. Disconnect the 2P connector (A) from the washer motor (B).
    Fig 1: Identifying Washer Motor & 2P Connector
    G05960103Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Test the motor by connecting battery power to the terminal No. 1 (or No. 2), and ground to terminal No. 2 (or No. 1) of the washer motor. The motor should run.
    • If the motor does not run, or fails to run smoothly, replace it.
    • If the motor runs smoothly, but little or no washer fluid is pumped, check for a disconnected or blocked washer hose, or a clogged washer motor outlet.
scientia non olet · About Mike's Workshop Manuals