Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Honda >> 2009 >> S2000 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Fuel And Emissions Systems) >> How to Set Readiness Codes >> Catalytic Converter Monitor and Readiness Code

Catalytic Converter Monitor and Readiness Code

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Honda S2000, 2004 Honda S2000, 2003 Honda S2000, 2002 Honda S2000, and 2001 Honda S2000. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Do not turn the ignition switch off during the procedure.
  • All readiness codes are cleared when the battery is disconnected or when the ECM is cleared with an OBD II scan tool or the HDS.
  • Low ambient temperatures or excessive stop-and-go traffic may increase the drive time needed to switch the readiness code from incomplete to complete.
  • The readiness code will not switch to complete until all the enable criteria are met.
  • If a fault in the secondary HO2S system caused the MIL to come on, the readiness code cannot be set to complete until you correct the fault.
scientia non olet · About Mike's Workshop Manuals