Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Honda >> 2009 >> Element SC, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 130 (VSA (Vehicle Stability Assist) System Components) >> Wheel Speed Sensor Replacement >> Rear

Wheel Speed Sensor Replacement: Rear

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Honda Odyssey, 2016 Honda Odyssey, 2015 Honda Odyssey, 2014 Honda Odyssey, and 2013 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to LOCK (0).
  2. Remove the clip (A), then disconnect the wheel speed sensor connector (B).
    Fig 1: Wheel Speed Sensor, Connector, Grommet, Clamp And Mounting Bolt Torque Specification (Rear)
    G06969842Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the wire guide rubbers and the clips.
  4. Remove the bolt and the wheel speed sensor (C).
  5. Remove the wire guide rubber (D) from the clamp (E), then pull out the wire harness from between the subframe and the body.
  6. Install the wheel speed sensor in the reverse order of removal, and note these items:
    • Do not twist the sensor wires.
    • If the wheel speed sensor comes in contact with the hub bearing unit, it is faulty.
    • Make sure there is no debris in the sensor mounting hole.
scientia non olet · About Mike's Workshop Manuals