Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Honda >> 2007 >> Fit Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Engine Control System (2TR-FE)) >> Accelerator Pedal >> On-Vehicle Inspection

On-Vehicle Inspection

WARNING: This page is about a different car, the 2007 Toyota Tacoma. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT ACCELERATOR PEDAL ASSEMBLY 
    1. Inspect the voltage.
      1. Connect the intelligent tester to the DLC3.
        2. Fig 1: Connecting Intelligent Tester (With CAN VIM) To DLC3
        G05198635Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
      2. Turn the ignition switch to ON.
      3. Turn the intelligent tester ON.
      4. Select the following menu items: DIAGNOSIS / ENHANCED OBD II / DATA LIST /ALL /ACCEL POS#1, ACCEL POS#2.
      5. Operate the accelerator pedal, then check that the ACCEL POS #1 and ACCEL POS #2 values are within the specified ranges.

        ACCEL POS #1 

        ACCELERATOR PEDAL CONDITION

        Accelerator Pedal Condition Specified Condition
        Released 0.5 to 1.1V
        Depressed 2.6 to 4.5 V

        ACCEL POS #2 

        ACCELERATOR PEDAL CONDITION AND SPECIFIED CONDITION

        Accelerator Pedal Condition Specified Condition
        Released 1.2 to 2.0 V
        Depressed 3.4 to 5.0 V

        If the result is not as specified, check the accelerator pedal, wire harness and ECM.

scientia non olet · About Mike's Workshop Manuals