Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Honda >> 2007 >> Fit Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Engine Control System (1GR-FE)) >> Accelerator Pedal >> On-Vehicle Inspection

On-Vehicle Inspection

WARNING: This page is about a different car, the 2007 Toyota Tacoma. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT ACCELERATOR PEDAL ROD 
    1. Check the voltage.
      1. Turn the ignition switch to ON.
      2. Turn the intelligent tester ON.
      3. Start the engine and warm it up.
      4. Select the following menu items: DIAGNOSIS / ENHANCED OBD II / DATA LIST / ALL / ACCEL POS #1, ACCEL POS #2.
      5. Operate the accelerator pedal, then check that the ACCEL POS #1 and ACCEL POS #2 values are within the specifications.
        Fig 1: Connecting Intelligent Tester (With CAN VIM) To DLC3
        G05198635Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

        Standard: 

        ACCELE POS #1 

        ACCELE POS #1

        Accelerator Pedal Condition Specified Condition
        Released 0.5 to 1.1V
        Depressed 2.5 to 4.5 V

        ACCELE POS #2 

        ACCELE POS #2

        Accelerator Pedal Condition Specified Condition
        Released 1.2 to 2.0 V
        Depressed 3.4 to 5.0 V

        If the result is not as specified, check the accelerator pedal rod, wire harness and ECM.

scientia non olet · About Mike's Workshop Manuals