Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Honda >> 2007 >> Fit Base, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wipers/Washers >> Washer Fluid Level Switch Test/ Replacement >> Canada models

Canada models

  1. Partially remove the left inner fender (see FRONT INNER FENDER REPLACEMENT ).
  2. Disconnect the 2P connector (A) from the washer fluid level switch (B).
    Fig 1: Identifying Washer Fluid Level Switch 2P Connector Terminals
    G05456688Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the washer fluid level switch from the washer reservoir.
    NOTE: Fluid may flow out of the opening.
  4. Check for continuity between the No. 1 and No. 2 terminals in each float position.
    • There should be continuity when the float is down.
    • There should be no continuity when the float is up.
  5. If the continuity is not as specified, replace the switch.

    If the continuity is as specified, go to step 5 in GAUGE CONTROL MODULE INPUT TEST , do the test for terminal C18.

scientia non olet · About Mike's Workshop Manuals