Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Honda >> 2007 >> Element SC, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Engine Block (V6)) >> Piston, Pin, and Connecting Rod Replacement >> Disassembly

Piston, Pin, and Connecting Rod Replacement: Disassembly

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Honda Crosstour, 2014 Honda Crosstour, 2013 Honda Crosstour, 2012 Honda Crosstour, and 2011 Honda Accord Crosstour. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the pistons from the engine block (see CRANKSHAFT AND PISTON REMOVAL  ).
  2. Apply new engine oil to the piston pin snap rings (A) and turn them in the ring grooves until the end gaps are lined up with the cutouts in the piston pin bores (B).
    NOTE: Take care not to damage the ring grooves.
    Fig 1: Identifying Piston Pin Snap Rings And Piston Pin Bores
    G06422301Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the snap rings (A) from both sides of each piston. Start at the cutout in the piston pin bore. Remove the snap rings carefully so they do not go flying or get lost. Wear eye protection.
    Fig 2: Removing Snap Rings From Piston
    G06422302Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Separately heat each piston and connecting rod, assembly to about 158 °F (70 °C), then remove the piston pin.
    Fig 3: Heating Piston And Connecting Rod
    G06422303Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About Mike's Workshop Manuals