Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Honda >> 2007 >> Element SC, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Tire Pressure Monitor Systems - Touring) >> TPMS Reset Procedures >> Tire Pressure Sensor Registration >> Memorizing Sensor ID (Using HDS)

Memorizing Sensor ID (Using HDS)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Honda Odyssey, 2009 Honda Odyssey, 2008 Honda Odyssey, 2007 Honda Odyssey, and 2006 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the ignition switch in OFF position, connect the HDS to the 16-pin Data Link Connector (DLC) located under the left side of the dashboard.
  2. Turn the ignition switch to ON position, and memorize the ID of the tire pressure sensor by following the screen prompts on the HDS. If all IDs are memorized properly, go to step  4. If TPM control unit fails to memorize one or more sensor IDs during learning process, go to next step.
  3. If one or more IDs fail to learn, causing DTCs to set, the HDS will provide a procedure to fix the problem that involves raising the vehicle. To solve this problem faster, perform the following:
    • Using HDS, clear all DTCs.
    • Using an assistant, start the learning process while driving the vehicle under 10 mph.
    NOTE: TPM control unit should now learn all 4 sensor IDs. If TPM control unit is still having trouble learning IDs, refer to appropriate service information.
  4. After the IDs are memorized, reduce the pressure in all 4 tires to less than specification, and check to see that the 4 tire indicators come on.
scientia non olet · About Mike's Workshop Manuals