Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Honda >> 2007 >> Element SC, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Tire Pressure Monitor Systems - Touring) >> TPMS Reset Procedures >> Pax System Reset

Pax System Reset

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Honda Odyssey, 2009 Honda Odyssey, 2008 Honda Odyssey, 2007 Honda Odyssey, and 2006 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: On models equipped with PAX tire systems, if a tire is repaired or replaced, the warning indicator (and the mileage counter that supports it) must be reset, no matter how far the vehicle was driven in the run flat mode.
  1. To put the gauge control module into the self-diagnostic mode, perform the following:
    • Turn the headlight switch to ON.
    • Press and hold the SELECT/RESET (Instrument panel brightness) knob.
    • Turn the ignition switch to ON (II).
    • Within 5 seconds, turn the headlights to AUTO, then to ON, and then to AUTO again.
    • Within 5 seconds, release the SELECT/RESET knob, then push and release the knob three times.
  2. Once the gauge control module is in the self-diagnostic mode, press and hold the INFO button on the steering wheel for 5 seconds to get to the CUSTOMIZE MENU.
  3. Use the INFO button to scroll through to the PAX RESET screen, then press the SEL/RESET button on the steering wheel.
  4. Use the INFO button to scroll to the appropriate wheel, and then press the SEL/RESET button on the steering wheel to reset the PAX warning system display. The screen should read "PAX RESET COMPLETED". Repeat this step for each wheel that needs to be reset.
  5. Use the INFO button to scroll through to EXIT, then press the SEL/RESET button.
  6. Turn the ignition switch to OFF to exit the self-diagnostic mode.
scientia non olet · About Mike's Workshop Manuals