Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Honda >> 2007 >> Civic GX >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Starting System) >> Clutch Interlock Switch Test

Clutch Interlock Switch Test

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2009 Honda S2000, 2008 Honda S2000, 2007 Honda S2000, 2006 Honda S2000, and 2005 Honda S2000. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the clutch interlock switch connector, then remove the clutch interlock switch (see CLUTCH PEDAL, CLUTCH PEDAL POSITION SWITCH, AND CLUTCH INTERLOCK SWITCH ADJUSTMENT ).
  2. Check the clutch interlock switch connector terminals for continuity. There should be no continuity between the terminals with the switch (A) released, and there should be continuity with the switch pressed.
    Fig 1: Identifying Terminal Side Of Male Terminals
    G06231532Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. If the clutch interlock switch is faulty, replace it.
  4. Install the clutch interlock switch, and adjust it (see CLUTCH PEDAL, CLUTCH PEDAL POSITION SWITCH, AND CLUTCH INTERLOCK SWITCH ADJUSTMENT ).
scientia non olet · About Mike's Workshop Manuals