OPEN/CLOSE function of the display does not work
- Turn the ignition switch OFF.
- Disconnect the navigation display connector B (10P) and CD changer connector A (18P).
- Check for continuity between navigation display connector B (10P) terminal No. 10 and body ground.Fig 1: Checking Continuity Between Navigation Display Connector B (10P) Terminal No. 10 And Body Ground
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there continuity?
YES - Repair short in the wire between navigation display connector B (10P) terminal No. 10 and CD changer connector A (18P) terminal No. 4.
NO - Go to step 4.
- Substitute a known-good navigation display, and check to see if the display opens and closes normally.
Does the display work normally?
YES - Replace the navigation display (see NAVIGATION DISPLAY REMOVAL/INSTALLATION ).
NO - Replace the CD changer (see AUDIO DISC CHANGER REMOVAL/INSTALLATION ).