DTC 66: VSA Pressure Sensor (Inside of VSA Modulator-Control Unit)
- Clear the DTC using the HDS (see HOW TO RETRIEVE DTCS ).
- Remove the HDS from the 16P DLC.
- Turn the ignition switch OFF, then turn it ON (II).
- Test-drive the vehicle.
Does the ABS indicator come on, and is DTC 25, 26,27, or 64 indicated?
YES - Do the appropriate troubleshooting for the DTC.
NO - Go to step 5.
- Do the VSA sensor neutral position memorization (see VSA SENSOR NEUTRAL POSITION MEMORIZATION ).
- Clear the DTC using the HDS (see HOW TO RETRIEVE DTCS ).
- Disconnect the HDS from the 16P DLC.
- Turn the ignition switch OFF, then turn it ON (II).
- Test-drive the vehicle.
Does the ABS indicator come on, and is DTC 66 indicated?
YES - Check for loose connector terminals and repair if necessary. Replace the VSA modulator-control unit (see VSA MODULATOR-CONTROL UNIT REMOVAL AND INSTALLATION ).
NO - The system is OK at this time.