Third Row Seat-back Release Cable Replacement

Special Tools Required

KTC trim tool set SOJATP2014

NOTE:

Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
Take care not to bend the cable.

Remove the third row seat-back recline lever (see THIRD ROW SEAT-BACK RECLINE LEVER REPLACEMENT ).
While holding the lever (A) open, carefully pry out the cover (B) with a flat-tip screwdriver to release the tabs (C), then remove the cover.

Fig 1: Removing Third Row Seat-Back Cover
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the recline cables (A). There is no inner recline cable on the right recline lever.

Fig 2: Disconnecting Recline Cables (Third Row Seat-Back)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the third row seat-back recline cable in the reverse order of removal, and make sure the cables are connected securely.