Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Honda >> 2000 >> S2000 >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Fuel And Emissions Systems) >> How to Set Readiness Codes >> Evaporative Emission (EVAP) Control System Monitor and Readiness Code >> Procedure

Evaporative Emission (EVAP) Control System Monitor and Readiness Code: Procedure

WARNING: This page is about a different car, the 2009 Honda S2000, 2008 Honda S2000, 2007 Honda S2000, and 2006 Honda S2000. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the HDS to the vehicle's data link connector (DLC).
  2. Start the engine.
  3. Select EVAP TEST in the INSPECTION MENU with the HDS, then select the FUNCTION TEST in the EVAP TEST MENU.
    • If the result is are normal, readiness is complete.
    • If the result is are not normal, go to the next step.
  4. Check for a Temporary DTC. If there is no DTC, one or more of the enable criteria were probably not met; repeat the procedure.
scientia non olet · About Mike's Workshop Manuals