Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Honda >> 2000 >> Prelude Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Engine Controls - Removal, Overhaul & Installation) >> Fuel System >> Fuel System Pressure Release

Fuel System Pressure Release

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2000 Isuzu VehiCROSS, 2000 Isuzu Trooper, 2000 Isuzu Rodeo, 2000 Isuzu Hombre, and 2000 Isuzu Amigo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosen fuel filler cap to relieve tank pressure. Remove fuel pump relay. See FUEL PUMP RELAY LOCATION  table.
    FUEL PUMP RELAY LOCATION

    Model Location
    Amigo & Rodeo On Right Fender Panel, Near Battery
    Hombre Underhood Fuse Block, On Left Fender Panel
    Trooper & VehiCROSS In Right Fenderwell Relay Box
  2. Start engine and allow it to run until it stalls. Loosen hose clamp of fuel line on side of pressure regulator coming from fuel line inlet distributor pipe.
  3. Cover fuel hose using a shop towel. Slowly pull hose from pressure regulator to relieve fuel pressure. When fuel stops leaking, reinstall hose and clamp.
scientia non olet · About Mike's Workshop Manuals