Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Honda >> 2000 >> Prelude Base, Standard >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Removal & Installation & Overhaul >> Ignition System >> Distributor >> Removal & Installation

Removal & Installation

Set No. 1 piston to TDC. Disconnect distributor harness connector(s). Disconnect spark plug wires from distributor cap. Remove distributor hold-down bolts. Remove distributor from cylinder head. To install, coat NEW "O" ring with engine oil and put into place. To complete installation, reverse removal procedure. Set timing to specification. See ON-VEHICLE ADJUSTMENTS article.

NOTE: Lugs on distributor shaft and mating grooves in camshaft end are offset to eliminate possibility of installing distributor 180 degrees out of time.
NOTE: Overhaul procedures are not available from manufacturer. See Fig 1-Fig 6 .
Fig 1: Exploded View Of Distributor (Accord 2.3L - F23A1 & F23A4 Engines)
G98A07134Courtesy of AMERICAN HONDA MOTOR CO., INC.
Fig 2: Exploded View Of Distributor (Accord 2.3L - F23A5 Engine)
G98D07135Courtesy of AMERICAN HONDA MOTOR CO., INC.
Fig 3: Exploded View Of Distributor (Civic - Hitachi)
G97G07245Courtesy of AMERICAN HONDA MOTOR CO., INC.
Fig 4: Exploded View Of Distributor (Civic - TEC)
G97I07246Courtesy of AMERICAN HONDA MOTOR CO., INC.
Fig 5: Exploded View Of Distributor (CR-V)
G97C07248Courtesy of AMERICAN HONDA MOTOR CO., INC.
Fig 6: Exploded View Of Distributor (Prelude)
G97B07243Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About Mike's Workshop Manuals