Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Honda >> 1995 >> Prelude SE, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls - Basic Testing - 2.2L) >> Ignition Checks >> Electronic Ignition System >> Ignition Coil Power Source

Ignition Coil Power Source

WARNING: This page is about a different variant/trim than selected.
  1. On Civic, remove distributor cap to check power source directly at coil. On all models, disconnect ignition coil primary leads. Turn ignition on. Using voltmeter, check voltage between ground and Black/Yellow wire terminal of ignition coil harness.
  2. Battery voltage should be present. If battery voltage is not present, check for open in Black/Yellow wire between coil and ignition switch.
scientia non olet · About Mike's Workshop Manuals