EVAP Purge Control Solenoid Valve

Disconnect vacuum hose from EVAP purge control diaphragm valve, located on charcoal canister. Connect vacuum gauge to hose. Start and idle engine. Engine coolant temperature must be below 167°F (75°C) on all engines except D15Z1. On D15Z1, temperature must be below 158°F (70°C).

If vacuum does not exist, go to step 4). If vacuum exists, unplug connector at EVAP purge control solenoid valve. See EVAP PURGE CONTROL SOLENOID LOCATION table. Measure voltage between specified wires. See EVAP PURGE CONTROL SOLENOID CONNECTOR IDENTIFICATION table.

EVAP PURGE CONTROL SOLENOID LOCATION

Application	Location
Accord	In Control Box On Firewall
Civic & Civic Del Sol	Left Of IAC Valve
Prelude	Near Throttle Position Sensor

EVAP PURGE CONTROL SOLENOID CONNECTOR IDENTIFICATION

Application	Positive Terminal Wire Color	Negative Terminal Wire Color
Accord & Prelude
(4-Pin Connector)	Black/Yellow	Red/Green
Civic & Civic Del Sol
(2-Pin Connector)	Yellow/Black	Red

If battery voltage exists, inspect vacuum hose for leaks, blockage and incorrect routing. If hose is okay, replace EVAP purge control solenoid valve. If voltage does not exist, measure voltage between positive terminal and chassis ground. If battery voltage does not exist, repair open circuit in appropriate positive wire. If voltage exists, check for open circuit between negative terminal and ECM. If wire is okay, replace ECM.
Warm engine to full operating temperature (cooling fan comes on). Turn off and restart engine. If vacuum now exists, go to CHARCOAL CANISTER . If vacuum does not exist, unplug connector at EVAP purge control solenoid valve.
If vacuum now exists, check for short circuit in negative wire between harness connector and ECM. If wire is okay, substitute known good ECM. Retest system. If system now operates properly, replace ECM. If vacuum still does not exist, check vacuum hose for leaks, blockage and improper routing. If hose is okay, replace EVAP purge control solenoid valve.