Throttle Position (TP) Sensor: Adjustment

NOTE: Perform all testing procedures with engine at normal operating temperature.

CAUTION: DO NOT use throttle stop screw to adjust throttle position sensor.

1. Disconnect negative battery cable. Disconnect electrical connector from TP sensor. Loosen TP sensor retaining screws. Insert specified feeler gauges between throttle lever and throttle stop screw. See Fig 1 .
2. Using ohmmeter, measure resistance between specified terminals at TP sensor. See THROTTLE POSITION (TP) SENSOR RESISTANCE  table. See Fig 2 . Rotate TP sensor until indicated resistance is as specified. Tighten TP sensor retaining screws.
3. Reconnect electrical connector. Ensure throttle opener is properly adjusted. See THROTTLE OPENER  under IDLE SPEED & MIXTURE.

Fig 1: Adjusting TP Sensor

Courtesy of GENERAL MOTORS CORP.

Fig 2: Identifying TP Sensor Terminals

Courtesy of GENERAL MOTORS CORP.