Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Geo >> 1993 >> Storm Base, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Testing >> Pulse Wiper System Tests >> Wipers Inoperative; Switch In INT Position

Wipers Inoperative; Switch In INT Position

  1. Turn ignition off. Unplug intermittent wiper relay. Using a DVOM, check resistance in Green/Red wire between intermittent wiper relay connector and ground. If resistance is greater than 3.0 ohms, go to next step. If resistance is less than 3.0 ohms, replace intermittent wiper relay.
  2. Unplug wiper/washer switch connector. Check resistance in Light Green/Red wire between wiper/washer switch connector and ground. If resistance is greater than 3.0 ohms, replace wiper/washer switch. If resistance is less than 3.0 ohms, repair open in Light Green/Red wire between wiper/washer switch and intermittent wiper relay.
scientia non olet · About Mike's Workshop Manuals