DTC Information And Inspection: Present/History

Clear the DTC with GDS.
(Turn the engine OFF and then, keep it ON)
Warm up the engine by the properly operable temperature.
Using GDS, select "Actuation Test" in the actuator section.
Conduct "Bleeding Control Command".
Check success/failure indication for bleeding (Vent the air) from the GDS.
- If bleeding (vent the air) is successful:
  Go to the "Verification of Vehicle Repair" procedure.
- If bleeding (vent the air) is failed:
  Replace AWD, and then go to the "System Inspection After Replacement".
  
  In AWD replacement, conduct "Clutch Learning Reset"