Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2025 >> GV70 2.5T Advanced >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> 4WD Control Diagnosis >> DTC P1960-00: AWD-Bleeding Pressure Error >> DTC Information And Inspection >> System Inspection after Replacement

System Inspection after Replacement

  1. Clear the DTC with GDS.

    (Turn OFF the engine and then, keep it ON)

  2. Warm up the engine by the properly operable temperature.
  3. Using GDS, click "Actuation Test" in the actuator section.
  4. Conduct "Bleeding Control Command".
  5. Check success/failure indication for bleeding (Vent the air) from the GDS.
    • If bleeding (vent the air) is successful:

      Go to the "Verification of Vehicle Repair" procedure.

    • If bleeding (vent the air) is failed:

      Conduct the actuation test again. If it fails more than 3 times, check proper connection of pressure sensor terminal and connectors.

scientia non olet · About Mike's Workshop Manuals