Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2024 >> G70 2.5T, AWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System Control Module (SRSCM) And Sensors >> Front Impact Sensor (FIS) >> Repair Procedures >> Installation

Repair Procedures: Installation

CAUTION:
  • Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
  1. Install a new front impact sensor.
  2. Tighten the front impact sensor mounting nut.

    Tightening torque: 

    8.9 - 9.9 N.m (0.9 - 1.0 kgf.m, 6.6 - 7.3 lb-ft)

  3. Connect the front impact sensor connector.
  4. Install the radiator assembly.
  5. Reconnect the battery negative cable.
  6. After installing the front impact sensor, confirm proper system operation:

    Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off.

scientia non olet · About Mike's Workshop Manuals