Repair Procedures: Inspection
WARNING: This page is about a different variant/trim than selected.
Information
- Inspect the connector thoroughly for looseness, poor connection, bending, corrosion, contamination, deformation, or damage.
- Disconnect the parking switch connector.
- Turn Ignition "ON", & engine "OFF".
- Measure the each signal in "P" range or "not p" range.
SIGNAL CODE DESCRIPTION
| Signal | P | Not P |
|---|---|---|
| S1 | 20.3% (10.0 - 38.4%) | 79.7% (41.1 - 90.0%) |
| S2 | 79.7% (90.0 - 61.6%) | 20.3% (58.9 - 10.0%) |