Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2023 >> G80 2.5T Advanced, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Brake System) >> Front Disc Brake >> Repair Procedures >> Inspection >> Front Brake Disc Runout Check

Front Brake Disc Runout Check

WARNING: This page is about a different car, the 2024 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place a dial gauge about 10 mm (0.2 in.) from the outer circumference of the brake disc, and measure the runout of the disc.

    Brake disc runout 

    Limit: 0.050 mm (0.0016 in.) or less (new one)

    G15549043Courtesy of HYUNDAI MOTOR AMERICA
  2. If the runout of the brake disc exceeds the limit specification, replace the disc, and then measure the runout again.
  3. If the runout does not meet the limit specification, remove the disc, turn it 180° and reinstall. Then check the runout of the brake disc again.
  4. If the runout cannot be corrected by changing the position of the brake disc, replace the brake disc.
scientia non olet · About Mike's Workshop Manuals