(Smart Key System - Smart Key Antenna (Rear Bumper) Removal And Installation)
Abbreviated Procedures
| Work | H/W | Tightening torque N.m (kgf.m/lb-ft) | SST/Equipment | Chemical | etc | |
|---|---|---|---|---|---|---|
|
||||||
| 1 | Disconnect the battery negative (-) terminal | - | - | Diagnostic tool | - | - |
| 2 | Remove the quarter garnish | Fastener | - | - | - | - |
| 3 | Remove the rear combination lamp cover [LH/RH] | - | - | - | - | - |
| 4 | Remove the rear combination lamp [LH/RH] | Screw | - | - | - | - |
| 5 | Disconnect the rear combination lamp connector [LH/RH] | - | - | - | - | - |
| 6 | Remove the rear bumper upper mounting clips | Clip | - | - | - | - |
| 7 | Remove the rear under cover | Clip | - | - | - | - |
| 8 | Remove the rear bumper beam assembly mounting bolts [LH/RH] | Bolt | 20.9 - 29.9 (2.1 - 3.1/15.4 - 22.1) | - | - | - |
| 9 | Disconnect the rear bumper main connector | - | - | - | - | - |
| 10 | Remove the mounting screws on the side of rear bumper | Screw | - | - | - | - |
| 11 | Remove the rear bumper assembly | - | - | - | - | - |
| 12 | Disconnect the back up lamp connector [LH/RH] | - | - | - | - | - |
| 13 | Remove the rear bumper beam wiring harness | - | - | - | - | - |
| 14 | Remove the rear bumper beam assembly | Clip | - | - | - | - |
| 15 | Disconnect the smart key antenna connector | - | - | - | - | - |
| 16 | Remove the smart key antenna | Screw | - | - | - | - |
|
||||||
| Install in the reverse order of removal | ||||||
|
||||||