DTC Setting Condition

Troubleshooting	Condition	Possible Cause
Main Action	Monitor the DTC status	Data learning has not taken place after replacing the relevant controller(s) No learning data is available after placing the new IAU* No learning data is available after placing the new BLE* Module No learning data is available after placing both the new IAU* and the new BLE* module BLE* Module errors Voltage errors of the battery (9V or less/16V or more)
Prerequisite Condition	Turn the ignition switch ON
Threshold Value	BLE* errors No learning between BLE* and IAU* Above BLE* input voltage (Maintain 9V or below & 16V or more for 2 sec)
Diagnosis Time	Immediately
DTC Clearing	Immediately after receiving a sign of "Normal Operation" from BLE* Module

NOTE: IAU*: "Identity Authentication Unit"
BLE*: "Bluetooth Low Energy"