Front Side Airbag

WARNING: This page is about a different car, the 2022 Genesis G90. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Be sure to install the harness wires so they will not pinch or interfere with other parts.

NOTE:

Do not open the lid of the side airbag cover.
Make sure that the airbag assembly cover is installed properly. Improper installation may prevent a proper deployment.

Disconnect the battery negative cable and wait for at least three minutes.
Place a side airbag on the side airbag frame and tighten the side airbag mounting nuts (2EA).
Tightening torque:

Nut: 5.9 - 7.8 N.m (0.6 - 0.8 kgf.m, 4.3 - 5.8 lb-ft)
Install the Front seat back cover.
(Refer to Body - "FRONT SEAT BACK COVER ")
Install the Front seat assembly.
(Refer to Body - "FRONT SEAT ASSEMBLY ")
Recline and slide the front seat forward fully, make sure the harness wires are not pinched of interfere with other parts.
Reconnect the battery negative cable.
After installing the side airbag (SAB), confirm proper system operation:

Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.