Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2021 >> G90 5.0 Ultimate, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (Smart Key System Diagnosis) >> DTC B1602-00: CAN Line Error >> Verification Of Repair >> Verification Of Vehicle Repair

Verification Of Vehicle Repair

WARNING: This page is about a different car, the 2022 Genesis G90. However, it is still accessible from the selected car via links, so may be relevant.

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and select "Diagnostic Trouble Codes (DTC)" mode.
  2. Clear DTC using a GDS.
  3. Drive the vehicle within DTC Enable conditions in General information.
  4. After selecting "Diagnostic Trouble Codes (DTC)" mode and check DTC is recorded again.
  5. Are any DTCs recorded?

    YES 

    • Go to the applicable troubleshooting procedure.

    NO 

    • System is performing to specification at this time.
scientia non olet · About Mike's Workshop Manuals