Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2021 >> G90 3.3T Premium, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Control System - 3.3L) >> Oil Pressure Sensor OPS >> Repair Procedures >> Inspection

Repair Procedures: Inspection

WARNING: This page is about a different car, the 2022 Genesis G90. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch OFF.
  2. Disconnect the OPS connector.
  3. Remove the OPS.

    (Refer to "REMOVAL ")

  4. After immersing the thermistor of the sensor into engine coolant, measure resistance between the OPS terminals 1 and 2.
  5. Check that the resistance is within the specification.

    Specification:  Refer to "SPECIFICATION "

scientia non olet · About Mike's Workshop Manuals