Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2021 >> G90 3.3T Premium, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis - 3.3L (3 Of 9) >> DTC P0136-00: O2 Sensor Circuit (Bank 1/Sensor 2) >> Wiring Inspection >> Signal Circuit Inspection >> Check resistance

Check resistance

  1. IG "OFF". Disconnect HO2S connector.
  2. Measure resistance between both ends of signal terminal of HO2S (B1/S2) harness.

    Specification:  Approx. 0Ω

  3. Is resistance within the specification?

    YES 

    NO 

    • Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
      NOTE: HO2S must have a clean air reference to function properly. The air is obtained by way of the sensor wire(s). Do not attempt to repair the wire(s), connector, or the terminals.
scientia non olet · About Mike's Workshop Manuals