Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2021 >> G80 2.5T Advanced, AWD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heater System >> Console Temperature Control Actuator >> Repair Procedures >> Inspection

Repair Procedures: Inspection

  1. Turn the ignition switch OFF.
  2. Disconnect the console temperature control actuator and console ON/OFF actuator connector.
  3. Verify that the console temperature actuator and console ON/OFF actuator operates to the cool position when connecting 12V to terminal 7 and grounding terminal 3. Verify that the temperature control actuator operates to the warm position when connected in reverse.
    G15555127Courtesy of HYUNDAI MOTOR AMERICA

    [Console temperature control actuator] 

    1. -
    2. -
    3. Warm position 4. Sensor ground
    4. Sensor ground
    5. Feedback signal
    6. Sensor power (+5V)
    7. Cool position (Console OFF)

    [Console temperature control (A) actuator] 

    1. -
    2. -
    3. Warm position
    4. Sensor ground
    5. Feedback signal
    6. Sensor power (+5V)
    7. Cool position (Console OFF)

    [Console ON/OFF actuator] 

    1. -
    2. -
    3. Console (OFF)
    4. Sensor ground
    5. Feedback signal
    6. Sensor power (+5V)
    7. Console (ON)
  4. Connect the console temperature control actuator and console ON/OFF actuator, console mode connector.
  5. Turn the ignition switch ON.
  6. Check the voltage between terminal 4 and 5
  7. If the measured voltage is not within specification, substitute with a known-good console temperature actuator and console ON/OFF actuator and then check for proper operation.
scientia non olet · About Mike's Workshop Manuals